PW900智能壓力調節器是我公司研制生產的新型工業自動控制儀表，該產品吸收了國外九十年代同類產品的優點，同時還具有它獨自的特點，特別適用于高溫熔體壓力的測量與控制，及電網波動較大的場合。該產品外形美觀、功能齊全、極好的抗干擾性能使系統可靠工作。
該表采用雙層四位數碼管分別顯示實際壓力值和設定值；輸出窗口單排條碼顯示輸出功率，具有壓力上、下限報警，可由繼電器觸點輸出、電壓脈沖輸出、雙向可控制硅驅動觸發器輸出；恒流（或恒壓）輸出，全自動面板調試程序，使系統校準只需輕輕一按；該表采用三種抗干擾措施，使調節器可靠工作；第一、采用光電隔離電路使輸入與微處理器隔離，微處理器與輸出隔離，電源與輸入、微處理器、輸出隔離；第二、采用軟件抗干擾措施，使軟件可靠工作；第三、采用硬件程序監視系統，使系統程序受到干擾后能自動恢復正常工作。經實踐表明采用以上抗干擾措施可使系統軟件有很高的可靠性，確保系統工作穩定、可靠，輸出功率為PID和模糊控制相結合，使手動自動無擾動切換，同時功率輸出值為步進輸出。
該產品廣泛應用于石油、化纖、塑料行業對高溫熔體壓力的測量與控制。
功能參數
窗口顯示：雙層四位、實際值和設定值同時顯示、輸出功率條碼顯示
其它功能：斷電保護、二路報警
工作時間：大于20000小時
配套使用：與變送器配套可實現壓力控制、控制精度可達±1kg
兼容性：完全替換Dynisco產品uPC660/uPR690壓力調節器
操作簡單化：①開機直接進入手動狀態；
②點按轉換鍵可直接設置控制壓力；
③按增加鍵可直接增加輸出功率；
④手動/自動無擾動切換；
⑤自動狀態條碼直觀顯示輸出功率；
⑥具有輸出功率及單一輸出功率限幅；
⑦具有輸出功率及單一輸出功率限幅。

技術指標
數字顯示：雙層四位
內分辨率：32000
外分辨率：0.01Mpa、0.02MPa、0.05Mpa
非線性：0.5%±1個字、0.2%±1個字
報警設置：上/下限0～99.99MPa
PID輸出：4-20mA、0-10V、1-5V、0-10mA、0-20mA（可選）
繼電器額定值：250VAC、5A
使用環境：—10～+50℃、80%RH
電源：85～265VAC
連續工作時間：長期
開口及安裝尺寸：90×90×110mm

出廠配置 序號 名稱 單位 數量 備注
1 PW900智能壓力調節器 臺 1
2 傳感器 支 1 選購件
3 電纜線 米 5 一端有插頭座
4 安裝架 套 1
5 使用說明 份 1
6 出廠合格證 份 1



PW 900 series of intelligent temp and pressure digital instruments are the products of our company. We are the initial designers and vendors of the double-function digital instruments. PW series consist of PW300, PW300dual, PW600, PW800 and PW900. They incorporate the advantages of the same products from foreign countries in 1990s, as well as new features are added. Actually, they are quite suitable for measurement and control at one point for temp and pressure. PW series are good-looking and of excellent EMC performance.



New features:

Two-layer digital LEDs with four-bit for each layer display actual pressure value and temp value;
Pressure and temp alarms can be easily set;
The output can be generated by relay, voltage pulse or silicon via constant voltage or constant current;
System operation is controlled by the key panel;
Calibration can be easily completed just by pressing CAL key on the key panel.


Three new technical methods are introduced to enhance the EMC performance:

Photoelectric modules insulate the microprocessor from input and output interface;
New anti-jamming methods are used in the system program;
A hardware monitor runs all the time, which can reset the system to normal operation from abnormal operation after distortion.


Parameters

Item
Description

Display
Two-layer structure, top for pressure and bottom for temp

Internal resolution
32,000

External resolution
0.01Mpa、0.02MPa、0.05Mpa

Pressure
0.01MPa, 0.02MPa and 0.05MPa can be automatically switched by key panel

Temp
0.1℃, 0.2℃, 0.5℃, 1℃,

Non-linearity
0.5%±1 point, 0.2%±1point

Alarm range
0~99.99MPa for pressure; 0~408℃ for temp

PID output
4~20mA, 0~10V, 1~5V, 0~10mA, 0~20mA

Default value of Relay
250V AC, 5A

Operating condition
-10~+50℃, 80%RH

Power supply
85~265V AC

Operation time
Continuously

Outer dimension
90×90×110mm, 45×45×110mm

Mounting dimension
90×90×110mm



Default Configuration

No.
Item
Qty
Note

1
PW900intelligent pressure controller
1


2
Sensor
1
Optional

4
Cable
1(5m)
One terminal with male connector

5
Mount device
1


6
Manual sheet
1


7
Certification
1